10/31/2023 0 Comments Pbp to gcode converter![]() ![]() Notice in the bottom panel that there are four numbers after the file name. IF you navigate to the system tab select Post Processors then select the GRBL-Laser PP Just load up an Image in the Height map editor and use the settings from the pic below. ![]() The PP is set up for GRBL this is 0 to 255 for spindle speed. Select the machining tab and select the PP. Simply put both the PP and the PPT in the post folder of CB. I've zipped up a PP and PPT pair and the test file I used to debug it. This can't be done with a PP alone you need a PPT to do it properly. ![]() In a recent post Dragonfly asked about a Laser PP for GRBL.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |